1. Adopt the modularization design and it canautomatically detect the laser power signal and water protection.
2. Adopt the zero-current semi-bridge soft switch circuit to ensure high efficiency and fast response.
3. The port control is simple and it’s suitable for high/low level signal.The TTL level can control the start and stop of the laser and the abnormal protection switch is added to check whether the external water and air is expedite.
4. It can be adjusted the laser power though the 0 to 5V analog signal,but also to input PWM signal to control the laser power.
5. The power supply has the function of open circuit protection. In the case of good grounding, the power supply can work in the open state for a short time to avoid the damage caused by the burst of the laser tube.
6. Each power supply must be tested in 60 ℃in a full load condition and switched 500 times in 7 second.